HIGH TEMPERATURE AUTOSTIC
LOW SHRINKING...LESS THAN 1%
Electrical - Domestic Appliances - Electronics - Coal Mines - Manufacturers of Stoves,Furnace & Boilers - Glass Manufacturers - R & D - Gas Appliances - Ceramics to Metal.
Autostic - a ceramic inorganic compound is a major advance over the 2-part epoxy resin type adhesives. Almost limitless applications in a wide range of industries. Adheres to Keyless surfaces, e.g. Polished Glass to Polished Silver. Withstands reverse stresses at all temperature variations.
- It Bonds
- It's a filler
- It's a coating
- It's a heat and abrasion barrier
Impervious to oil, gasoline, acids and alkalies including concentrated sulfuric acid - has low thermal conductivity. Excellent electrical insulation for all voltages whether AC or DC and up to 20 radio MHz. Coat electrical windings for motors (replacing shellacs).
Applications: Coats glass to withstand higher temperatures - glass to metal - glass to ceramics - metal to metal- asbestos to glass - ferrite to ferrite- glass to ferrite - carbon to metal - sealing castings - gas joint sealing - electric muffle linings - solder mask-fuse coatings - masksfor heat treating furnace kilns - coats brick and mortar - coke burning appliances. Instrument Assemblies - fill in cracks in stoves: thermocouples - brake linings - quartz to metal - induction coils - thermocouples coating - magnets- potting- insulators- thermocouplers- repair tube furnaces- high temperature caulking - coat wooden patterns - WILL NOT ATTACK ANY METALS.
Moldability: Can be molded using polyethylene, teflon or nylon molds or make molds from inert-high density plastics. Can be machined - milled - drilled- tapped- sawcut- mold with additives such as mica dust providing additional insulating properties.
MANUFACTURING FIREPROOF BULKHEAD PANELS ON SHIPS FIREPROOFING BUILDING MATERIALS PANELS, CEILING TILE, ETC.ACID TANKS - KILNS - CHEMICAL SEWERS
TESTING OF AUTOSTIC Compressive Strength....28.4 N/mm2....(4100 psi)
Tensile Strength (between steel plates)...1.7 N/mm2....(250 psi)
Maximum Tensile Stress (bending test)....7.1 N/mm2....(1030 psi)
Shrinkage 1.5% Density....2.08 g/cm3....(130 pcf)
Hardness....VPN6....(1 kg load)
Volume Resistivity....2.9 x 109 ohm/cm
Electrical Capacitance....3.75 x 10-9 Farads
Coefficient of thermal expansion....18.1 x 10-6 1/K
(linear expansion)..... (or 18.1 x 10-6mm/mm/°C or 10.1 x 10-6in/in/°F)
Model No. 15006, 7 lb. can (3kg) Thick (Trowel On).